Ricoh MIB-II - Manual (Page 201)

Operating Instructions Administrator Reference
201
WINS
Use the wins command to configure the WINS server settings
For more information about WINS server settings, see p.233 “Configuring a WINS Server” .
❖ ❖ ❖ ❖ Configuration
Use the set command to make WINS active or inactive.
msh> set wins {on|off}
• "on" means active and "off" means inactive.
auth [open|shared] You can set the authorized mode when using WEP. The
specified value and the authorized mode are as follows:
open: Open system authorized (default)
shared: Shared key authorized
rate [auto|11m|5.5m|2m|1m] You can set the IEEE 802.11b transmitting speed.
The transmitting speed you specify here is the speed at
which data is sent. You can receive data at any speed.
auto: automatically set (default)
11m: 11 Mbps fixed
5.5m: 5.5 Mbps fixed
2m: 2 Mbps fixed
1m: 1 Mbps fixed
Parameter Value to be configured