Ricoh MIB-II - Manual (Page 197)

Operating Instructions Administrator Reference
197
SMB
Use the smb command to configure or delete the computer name or workgroup name for NetBEUI.
msh >smb parameter
ROUTE
Use the route command to control the routing table.
This command allows you to configure and display routing information. You can change the network
configuration from a remote computer using this command.
Note
❒ The maximum number of routing tables are 16.
Parameter Settings
smb comp Your computer name consisting of up to 13 characters
smb group Workgroup name consisting of up to 15 characters
smb comment Comment consisting of up to 31 characters
smb clear comp Clears complete name
smb clear group Clears Workgroup name
smb clear comment Clears comment
Parameter Topics of setting
route add {host | net} destination
gateway Adds a host/network route to "destination", and a gateway address to "gateway"
in the table. Host becomes the default setting.