Spool printing, Operating instructions administrator reference – Ricoh MIB-II User Manual
Page 181
Operating Instructions
Administrator Reference
181
Spool Printing
With Spool Printing, the whole data of a print job is saved in the Printer Hard Disk before printing. To
use this function, set it from the menu. See
Important
❒
Do not turn off the printer or the computer when a print job is being spooled and the Data In indicator
is blinking. If you do, the print job will remain in the Printer Hard Disk and be printed when the printer
is turned on.
Limitation
❒
Spool Printing does not appear unless the optional Printer Hard Disk is installed.
❒
Data that has been received in the protocol other than LPD or IPP cannot be spooled.
❒
Up to 50 jobs (approximately 1000 MB) can be spooled at a time.
❒
When Spool Printing is on, the size of a single print job cannot exceed 500 MB.
❒
When sending spooled print jobs from more than one computer at the same time, up to five LPR
jobs and one IPP job can be spooled. Jobs exceeding the maximum number cannot be spooled.
Wait until the number of spooled print jobs falls below the maximum.
Note
❒
When "On" is selected, the first print will take time.
Note
❒
Spool jobs stored in the machine can be viewed or deleted using a Web browser.