Ricoh MIB-II - Manual (Page 53)

Operating Instructions Administrator Reference
53
Reference
For more information about how to make the above settings, see "Windows NT 4.0 Configuration"
in Printer Client Reference that comes with this printer.
If DHCP is used to assign IP addresses, see p.68 “Bidirectional transmission” .
Note
❒ After setting the IP address, use the ping command to confirm that it has been set correctly.
A Click [ Start ], point to [ Programs ], and then click [ Command Prompt ].
B Type the following: (Example IP address is 192.168.15.16)
C:> ping 192.168.15.16
If the address has been configured correctly, the following message appears.
Reply from 192.168.15.16
If the address has been configured incorrectly, the following message appears.
Request timed out.
Configuring a Windows NT computer
Follow these steps to configure a Windows NT computer to use the TCP/IP protocol.
AAAA
Open [ Control Panel ] and double-click the [ Network ] icon. Confirm that "TCP/IP Protocol" is
listed in the [ Network protocols ] box under the [ Protocols ] tab.
Note
❒ If the TCP/IP protocol is not installed, click [ Add ] under the [ Protocols ] tab and install it. For more
information about installing the TCP/IP protocol, see Windows NT Help.
BBBB
Configure the TCP/IP protocols with an appropriate IP address, subnet mask and other set-
tings.
Confirm that the settings are correct with the network administrator.