Texas Instruments MSP430x4xx - Manual (Page 200)

Watchdog Timer Registers
10-10 Watchdog Timer, Watchdog Timer+
IFG1, Interrupt Flag Register 1
7 6 5 4 3 2 1 0
NMIIFG WDTIFG
rw−(0) rw−(0)
Bits
7-5 These bits may be used by other modules. See device-specific datasheet.
NMIIFG Bit 4 NMI interrupt flag. NMIIFG must be reset by software. Because other bits in
IFG1 may be used for other modules, it is recommended to clear NMIIFG by
using
BIS.B or BIC.B instructions, rather than MOV.B or CLR.B instructions.
0 No interrupt pending
1 Interrupt pending
Bits
3-1 These bits may be used by other modules. See device-specific datasheet.
WDTIFG Bit 0 Watchdog timer interrupt flag. In watchdog mode, WDTIFG remains set until
reset by software. In interval mode, WDTIFG is reset automatically by
servicing the interrupt, or can be reset by software. Because other bits in IFG1
may be used for other modules, it is recommended to clear WDTIFG by using
BIS.B or BIC.B instructions, rather than MOV.B or CLR.B instructions.
0 No interrupt pending
1 Interrupt pending