Texas Instruments MSP430x4xx - Manual (Page 49)

Addressing Modes
3-15 RISC 16-Bit CPU
3.3.6 Indirect Autoincrement Mode
The indirect autoincrement mode is described in Table 3−9.
Table 3−9. Indirect Autoincrement Mode Description
Assembler Code Content of ROM
MOV @R10+,0(R11) MOV @R10+,0(R11)
Length: One or two words
Operation: Move the contents of the source address (contents of R10) to
the destination address (contents of R11). Register R10 is
incremented by 1 for a byte operation, or 2 for a word
operation after the fetch; it points to the next address without
any overhead. This is useful for table processing.
Comment: Valid only for source operand. The substitute for destination
operand is 0(Rd) plus second instruction INCD Rd.
Example: MOV @R10+,0(R11)
00000h
Address
Space
04ABBh PC
0FF16h
0FF14h
0FF12h
0xxxxh
05BC1h
0FA34h
0FA32h
0FA30h 0xxxxh
0xxxxh
01234h
010AAh
010A8h
010A6h 0xxxxh
0FA32h
010A8h
R10
R11
Register
Before:
Address
Space
0xxxxh
05BC1h
0FA34h
0FA32h
0FA30h 0xxxxh
0xxxxh
05BC1h
010AAh
010A8h
010A6h 0xxxxh
0FA34h R10
R11
Register
After:
0xxxxh
0xxxxh
0FF18h
00000h
04ABBh
PC
0FF16h
0FF14h
0FF12h
0xxxxh
0xxxxh
0FF18h
010A8h
The autoincrementing of the register contents occurs after the operand is
fetched. This is shown in Figure 3−8.
Figure 3−8. Operand Fetch Operation
Instruction Address Operand
+1/ +2