Xylem 6-Series Multiparameter - Manual (Page 106)

Sondes Section 2
YSI Incorporated Environmental Monitoring Systems Operations Manual 2-100
PAR1 Output from special photosynthetically active radiation sensor in mv or
Photon Flux Density in umoles/sec/m2
PAR 2 Output from special photosynthetically active radiation sensor in mv or
Photon Flux Density in umoles/sec/m2
2.9.7 SENSOR
The Sensor menu allows you to Enable or Disable (turn on or off) any available sensor and, in some cases,
to select the port in which your sensor is installed.
From the Sonde Main menu select 7-Sensor and the following display will appear.
Note that the exact appearance of this menu will vary depending upon the sensors available on your sonde.
When a particular sensor is active, an asterisk will appear in the parentheses associated with the selection.
In this example the time, temperature, conductivity, dissolved oxygen, pH, ORP, and battery sensors are
enabled. To disable a sensor, simply press the number of the active sensor or port, and the asterisk will
disappear.
For the ISE and Optic selections, press the appropriate number, and then enable or disable the sensor using
the submenu choices. Be certain that the appropriate sensor is “enabled” in the submenu according to the
sonde bulkhead port in which it is physically installed. For example, if an ammonium sensor is placed in
the port labeled “3” on the bulkhead, enable the sensor as ISE3 in the menu structure.
The following screen is the submenu selection structure for ISE3, ISE4 and ISE5.
--------------Select type--------------
1-( )ISE3 NH4+
2-( )ISE3 NO3-
3-( )ISE3 Cl-
4-( )ISE3 PAR1
Select option (0 for previous menu):
------------Sensors enabled------------
1-(*)Time 7-( )ISE3 NONE
2-(*)Temperature 8-( )ISE4 NONE
3-(*)Conductivity 9-( )ISE5 NONE
4-(*)Dissolved Oxy A-( )Optic T
5-(*)ISE1 pH B-( )Optic C
6-(*)ISE2 Orp C-(*)Battery
Select option (0 for previous menu):