Xylem 6-Series Multiparameter - Manual (Page 35)

Sondes Section 2
YSI Incorporated Environmental Monitoring Systems Operations Manual 2-29
Select 1-Date & time. An asterisk will appear next to each selection to confirm the entry. Press 4 and 5 to
activate the date and time functions. Pay particular attention to the date format that you have chosen when
entering date. You must use the 24-hour clock format for entering time. Option 4- ( ) 4 digit year may be
used so that the date will appear with either a two or four digit year display. If you do not enter the correct
year format (8/30/98 for 2-digit, 8/30/1998 for 4 digit) your entry will be rejected.
-----------Date & time setup-----------
1-(*)m/d/y 4-( )4 digit year
2-( )d/m/y 5-Date=08/30/98
3-( )y/m/d 6-Time=11:12:30
Select option (0 for previous menu):
Select 4-Instrument ID from the System setup menu to record the instrument ID number (usually the
instrument serial number), and press Enter. A prompt will appear which will allow you to type in the
serial number of your sonde. This will make sure that any data that is collected is associated with a
particular sonde. Note that the selection 5-Circuit Board SN shows the serial number of the PCB that is
resident in your sonde (not the entire system as for Instrument ID). Unlike the Instrument ID, the user
cannot change the Circuit Board SN. The 6-GLP filename and 7-SDI-12 address selections will be
explained in Section 2.9.5
Press Esc or 0 to return to the System setup menu.
Then press Esc or 0 again to return to the Main menu.
------------------Main-----------------
1-Run 5-System
2-Calibrate 6-Report
3-File 7-Sensor
4-Status 8-Advanced
Select option (0 for previous menu):