Yokogawa PC-Based MX100 - Manual (Page 178)

7-38
SM MX100-01E
Remove the Adapter
15. Remove the screw indicated by the arrow in the top of the figure below.
Then push the tab indicated by the arrow in the bottom of the figure below.
Plastic cover
16. Free the two tabs indicated by the arrow in the figure below.
17. Remove the adapter
Bracket
Adapter
Disassembling the Power Assembly
18. Remove the three screws as indicated by the arrows in the figure below.
19. Pull out the Inlet Board (-M) (or, if the power supply inlet is -W, the part
corresponding to the Inlet Board is removed)
7.9 Disassembling the MX100 Main Module