GW Instek GSP-930 Programming Manual - Manual (Page 143)

REMOTE CONTROL
141
Syntax [:SENSe]:PMETer:LLIMit <ampl>
Query Syntax [:SENSe]:PMETer:LLIMit?
Parameter <ampl> <NRf> power unit, default = dBm
Return parameter <NR3> Unit = current unit.
Example :PMET:LLIM 0
[:SENSe]:PMETer:PSENsor:MODE
Set
Query
Description Sets or queries the power meter sensor mode.
Syntax [:SENSe]:PMETer:PSENsor:MODE
{LOWNoise|FASTer}
Query Syntax [:SENSe]:PMETer:PSENsor:MODE?
Parameter/
Return parameter LOWNoise Sets the power meter mode to low noise.
FASTer
Set the power meter mode to fast.
Example :PMET:PSEN:MODE
[:SENSe]:PMETer:RECording:TIME
Set
Query
Description Sets or queries the power meter recording time.
Syntax [:SENSe]:PMETer:RECording:TIME
<hour>,<minute>,<second>
Query Syntax [:SENSe]:PMETer:RECording:TIME?
Parameter/
Return parameter <hour> <NR1>Recording time: hours.
<minute> <NR1>Recording time: minutes.
<second> <NR1>Recording time: seconds.
Example :PMET:REC:TIME 1,10,30
[:SENSe]:PMETer:RECording:TIME:STEP
Set
Query
Description Sets or queries the power meter recording interval
in seconds.
Syntax [:SENSe]:PMETer:RECording:TIME:STEP <time>