GW Instek GSP-930 Programming Manual - Manual (Page 63)

REMOTE CONTROL
61
*RST
Set
Description *RST will perform a factory reset.
Syntax *RST
*SRE
Set
Query
Description Sets or queries the Service Request Enable register.
The Service Request Enable register determines
which registers of the Status Byte register are able
to generate service requests.
Syntax
Query Syntax *SRE <NR1>
*SRE?
Parameter <NR1> 0~255
Return parameter <NR1> Returns the bit sum of the Service Request
Enable register.
*STB?
Query
Description Queries the bit sum of the Status Byte register with
MSS (Master summary Status).
Query Syntax *STB?
Return parameter <NR1> Returns the bit sum of the Status Byte register
with the MSS bit (bit 6).
*TST?
Query
Description Returns the result of a self-test. The GSP-930 does
not support performing a selftest and thus will
always return “0” for this query.
Query Syntax *TST?
Return parameter 0 Returns “0”