Allied Telesis AT-FS970M Series - Manual (Page 1065)

AT-FS970M Switch Command Line User’s Guide
1065
Disabling 802.1x Port-Based Network Access Control on the Switch
To disable 802.1x port-based network access control on the switch so that
the ports forward packets without authentication, go to the Global
Configuration mode and enter the NO AAA AUTHENTICATION DOT1X
DEFAULT GROUP RADIUS command. Here is the command:
awplus> enable
awplus# configure terminal
awplus(config)# no aaa authentication dot1x default group
radius
Note
The switch retains the configuration settings of the authenticator and
supplicant ports when 802.1x port-based network access control is
deactivated. Authenticator ports will also not forward traffic of
connected hosts until the dot1x interface configuration has also
been negated.