Allied Telesis AT-FS970M Series - Manual (Page 646)

Chapter 42: DHCP Snooping Commands
646
SHOW ARP SECURITY
Syntax
show arp security
Parameters
None
Mode
Privilege Exec mode
Description
Use this command to display the ARP security configuration for the
specified ports or all ports.
Example
This example displays the ARP security configuration on the switch:
awplus> enable
awplus# show arp security
See Figure 120 for a sample display. See Table 70 on page 647 for an
explanation of the parameters in this display.
Figure 120. SHOW ARP SECURITY Command
awplus# show arp security
Arp Security Information:
Total VLANs enabled...............2
Total VLANs disabled..............10
vlan1...............Disabled
vlan2...............Disabled
vlan3...............Disabled
vlan4...............Disabled
vlan5...............Disabled
vlan100.............Disabled
vlan101.............Disabled
vlan102.............Disabled
vlan103.............Disabled
vlan104.............Disabled
vlan105.............Enabled
vlan1000............Enabled