Allied Telesis AT-FS970M Series - Manual (Page 1186)

Chapter 74: sFlow Agent
1186
Configuring the sFlow Agent
The command for defining the IP address of the sFlow collector is the
SFLOW COLLECTOR IP command. The command, which is located in
the Global Configuration mode, has this format:
sflow collector ip ipaddress port udp_port
The IPADDRESS parameter specifies the IP address of the collector and
the UDP_PORT parameter its UDP port. This example specifies the IP
address of the sFlow collector as 154.122.11.24 and the UDP port as
6300:
awplus> enable
awplus# configure terminal
awplus(config)# sflow collector ip 154.122.11.24 port 6300
After configuring the agent, go to the next section to configure the ports
whose performance data is to be sent to the collector.