Allied Telesis AT-FS970M Series - Manual (Page 456)

Chapter 26: Port Mirror Commands
456
SHOW MIRROR
Syntax
show mirror
Parameters
None
Modes
Privileged Exec mode
Description
Use this command to display the source and destination ports of the port
mirror on the switch. An example is shown in Figure 99.
Figure 99. SHOW MIRROR Command
The fields are described in Table 43.
Mirror Test Port Name: port1.0.22
Mirror option: Enabled
Mirror direction: both
Monitored Port Name: port1.0.1
Mirror Test Port Name: port1.0.22
Mirror option: Enabled
Mirror direction: receive
Monitored Port Name: port1.0.4 Destination Port
Source Port
Destination Port
Source Port
Table 43. SHOW MIRROR Command
Parameter Description
Mirror Test Port Name The destination port of the port mirror. The
switch can have only one destination port.
Mirror option: The status of the port mirror on the source
port. This is always enabled.