Allied Telesis AT-FS970M Series - Manual (Page 1244)

Chapter 77: LLDP and LLDP-MED Commands
1244
LLDP HOLDTIME-MULTIPLIER
Syntax
lldp holdtime-multiplier holdtime-multiplier
Parameters
holdtime-multiplier
Specifies the holdtime multiplier value. The range is 2 to 10.
Mode
Global Configuration mode
Description
Use this command to set the holdtime multiplier value. The transmit
interval is multiplied by the holdtime multiplier to give the Time To Live
(TTL) the switch advertises to the neighbors. The transmit interval is set
with “LLDP TIMER” on page 1257.
Confirmation Command
“SHOW LLDP” on page 1279.
Example
This example sets the holdtime multiplier to 7:
awplus> enable
awplus# configure terminal
awplus(config)# lldp holdtime-multiplier 7