Allied Telesis AT-FS970M Series - Manual (Page 1846)

Chapter 105: Routing Information Protocol (RIP) Commands
1846
AUTO-SUMMARY
Syntax
auto-summary
Parameters
None
Mode
Routing Configuration mode
Description
Use this command to activate automatic route summarization to
consolidate the routes in RIP update packets. By default, automatic
summarization is enabled. For RIP Version 1, automatic summarization is
always used and cannot be disabled. For RIP Version 2, you can enable
and disable automatic summarization.
Confirmation Command
“SHOW IP RIP INTERFACE” on page 1879
Example
The following example enables automatic route summarization in RIP
Version 2:
awplus> enable
awplus# configure terminal
awplus(config)# router rip
awplus(config-router)# auto-summary