Allied Telesis AT-FS970M Series - Manual (Page 1105)

AT-FS970M Switch Command Line User’s Guide
1105
NO AUTH REAUTHENTICATION
Syntax
no auth reauthentication
Parameters
None
Mode
Port Interface mode
Description
Use this command to remove reauthentication from authenticator ports so
that supplicants do not have to periodically reauthenticate after the initial
authentication. Reauthentication is still required if there is a change to the
status of the link between a supplicant and the switch, or the switch is
reset or power cycled.
Confirmation Command
“SHOW AUTH-MAC INTERFACE” on page 1109
“SHOW DOT1X INTERFACE” on page 1114
Example
This example deactivates reauthentication on port 1.0.2:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# no auth reauthentication