Allied Telesis AT-FS970M Series - Manual (Page 1840)

Chapter 104: Routing Information Protocol (RIP)
1840
Displaying Routing Information with RIP
To confirm that routes are dynamically added by RIP, use the SHOW IP
RIP command.
S1# show ip rip
Figure 283 is an example of the information the command displays.
Figure 283. SHOW IP RIP Command
The columns in Figure 283 are defined in Table 257 on page 1876.
Codes: R - RIP, Rc - RIP connected, Rs - RIP static
C - Connected, S - Static
Network Next hop Metric From If Time
Rc 10.10.10.0/24 1 vlan10
Rc 10.10.50.0/24 1 vlan50
C 192.168.99.0/24 1 vlan1
R 192.168.20.0/24 10.10.10.32 10.10.10.3 vlan10 00:00:19
The R indicates that this network entry is added through RIP.