Allied Telesis AT-FS970M Series - Manual (Page 740)

Chapter 50: LACP Commands
740
LACP SYSTEM-PRIORITY
Syntax
lacp system-priority priority
Parameters
priority
Specifies the LACP system priority value for the switch. The range
is 1 to 65535.
Mode
Global Configuration mode
Description
Use this command to set the LACP priority of the switch. The switch uses
the LACP priority to resolve conflicts with other network devices when it
creates aggregate trunks.
Confirmation Command
“SHOW LACP SYS-ID” on page 748
Note
The value is set as an integer with this command and displayed in
hexadecimal format by the SHOW LACP SYS-ID command.
Example
This example assigns the system priority 200 to the switch:
awplus> enable
awplus# configure terminal
awplus(config)# lacp system-priority 200