Link-flap duration – Allied Telesis AT-FS970M Series User Manual
Page 438
Chapter 24: Link-flap Protection Commands
438
LINK-FLAP DURATION
Syntax
link-flap duration <20 - 65535>
Parameters
duration
Indicates the time period that defines a link flap event. The range is
20 to 65535 seconds. The default is 60 seconds.
Mode
Global Configuration mode
Description
Use this command to specify the time period the switch uses to determine
whether a port has experienced a link flap event. A link flap event occurs
on a port when its link state changes a defined number of times in a
defined period of time. The number of link state changes, referred to as
the rate, is set with “LINK-FLAP RATE” on page 440. The duration is set
with this command.
Confirmation Command
Example
This example sets the link-flap duration to two minutes:
awplus> enable
awplus# configure terminal
awplus(config)# link-flap duration 120