Allied Telesis AT-FS970M Series - Manual (Page 174)

Chapter 8: Basic Switch Management Commands
174
SNMP-SERVER CONTACT
Syntax
snmp-server contact contact
Parameters
contact
Specifies the name of the person responsible for managing the
switch. The name can be up to 255 alphanumeric characters in
length. Spaces and special characters are allowed.
Mode
Global Configuration mode
Description
Use this command to add contact information to the switch. The contact
information is usually the name of the person who is responsible for
managing the unit.
To remove the current contact information without adding a new contact,
use the NO form of this command.
Confirmation Command
“SHOW SYSTEM” on page 169
Example
This example assigns the contact “JSmith_ex5441” to the switch:
awplus> enable
awplus# configure terminal
awplus(config)# snmp-server contact JSmith_ex5441
This example removes the current contact information:
awplus> enable
awplus# configure terminal
awplus(config)# no snmp-server contact