Allied Telesis AT-FS970M Series - Manual (Page 1156)

Chapter 72: SNMPv1 and SNMPv2c Commands
1156
SNMP TRAP LINK-STATUS
Syntax
snmp trap link-status
Parameters
None
Mode
Port Interface mode
Description
Use this command to enable SNMP to transmit link status notifications
(traps) when ports establish links (linkUp) or lose links (linkDown) to
network devices.
Confirmation Command
“SHOW INTERFACE” on page 229
Example
This example configures the switch to transmit link status notifications
whenever links are established or lost on ports 1 to 4:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.1-port1.0.4
awplus(config-if)# snmp trap link-status