Allied Telesis AT-FS970M Series - Manual (Page 1624)

Chapter 97: ACL Commands
1624
TIME-RANGE
Syntax
time-range <time-range-name>
Parameters
time-range-name
Specifies a name of a time range.
Mode
Global Configuration mode
Description
This command allows you to define the name of a time range and enter
the Configuration Time-Range mode. Time ranges are supported by both
IP and IPv6 addresses.
Use the no form of this command, NO TIME-RANGE, to remove a time
range.
Examples
This example enters the Configuration Time-range mode with a time-
range called “tcp”:
awplus> enable
awplus# configure terminal
awplus(config)# time-range tcp
awplus(config-time-range)#
This example exits the Configuration Time-range mode with a time-range
called “udp:”
awplus> enable
awplus# configure terminal
awplus(config)# time-range udp
awplus(config-time-range)# no time-range udp