Allied Telesis AT-FS970M Series - Manual (Page 1098)

Chapter 70: 802.1x Port-based Network Access Control Commands
1098
DOT1X SUPPLICANT-PARAMS MAX-START
Syntax
dot1x supplicant-params max-start value
Parameters
value
Specifies the maximum number of tries by a supplicant to contact
an authenticator. The range is 1 to 10. The default is 3.
Mode
Port Interface mode
Description
Use this command to specify the maximum number of times a supplicant
sends EAPOL-Start frames before assuming that there is no authenticator
present. The range is 1 to 10. The default is 3.
Confirmation Command
“SHOW RUNNING-CONFIG INTERFACE” on page 240
Example
This example sets the maximum number of attempts on supplicant port
1.0.12 to 4:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.12
awplus(config-if)# dot1x supplicant-params max-start 4