RADWAG BALANCES 3Y SERIES - Manual (Page 149)

- 149 -
•
Press START located in a bottom part of a parameters settings
window. Program shall proceed to the main window of product control, used
for entering data.
Caution:
If before control:
•
Load has not been removed from the weighing pan or if other requirements
for zeroing have not been fulfilled (e.g. unstable indication), than message
<-Err 2> shall be displayed. Upon noticing <-Err 2> message the user shall
unload the balance and wait until all zeroing requirements are met,
•
The user has not logged in or is logged but has not got the right access to
perform control, than <No authority/Access denied> message shall be
displayed,
•
The user has not selected product out of database than <Product not
chosen> message shall be displayed.
27.6. Abort control procedure
The user may abort procedure being in progress at any chosen moment, to do it
button
(abort control) must be pressed. The button is located in bottom
part of the window.
Upon pressing the button
(abort control) the following message is
displayed
To abort control the user must press button
, the program gets back to a
setting window of PGC mode. Control report with status <Aborted> is saved to
< Controls> database.
To proceed with the control the user must press button
.