Chapter 8, Viewing the adapter web, 8viewing the adapter web pages – Rockwell Automation 20-COMM-E PowerFlex EtherNet/IP Adapter User Manual
Page 209
20-COMM-E EtherNet/IP Adapter User Manual
Publication 20COMM-UM010G-EN-P
Chapter
8
Viewing the Adapter Web Pages
This chapter provides instructions on how to monitor the adapter and
connected PowerFlex drive by using the adapter’s web interface.
Future enhancements may result in adapter web pages that look different
than the examples shown in this chapter.
Enabling the Adapter Web
Pages
After the adapter is configured and operating, you can view its web pages.
They present information about the adapter, the drive to which it is
connected, and the other DPI devices connected to the drive such as a HIM.
• Series A adapter, firmware 2.003 or earlier—By default the adapter web
pages are enabled. To disable the web pages, use Bit 0 of Parameter 54
- [Access Control]. See
Setting Web Access Control on page 3-15
for
more information.
• Series B adapter, firmware 3.xxx or later—By default the adapter web
pages are disabled. To enable the web pages, set the Web Pages Switch
(SW2 in
) to its ‘Enable Web’ position and reset the adapter.
Parameter 55 - [Web Enable] can be used to display the setting (1 =
Enabled or 0 = Disabled) of this switch.
Viewing the Web Pages
The adapter can be configured to automatically send e-mail messages to
desired addresses when selected drive faults occur and/or are cleared, and/or
when the adapter takes a communication or idle fault action.
For Series A adapters, Bit 1 of Parameter 54 - [Access Control] can be
used to protect the configured settings for the e-mail messaging feature. For
Series B adapters, Bit 0 of Parameter 56 - [Web Features] can be used to
protect the configured settings. For more details, see
Notification Web Page on page 8-6
Topic
Page
Enabling the Adapter Web Pages
Configure E-mail Notification Web Page
TIP: Series A adapter web pages are enabled differently than Series B.