Chapter 2, Installing the adapter, Preparing for an installation – Rockwell Automation 20-COMM-E PowerFlex EtherNet/IP Adapter User Manual

Page 21: Preparing for an installation -1, 2installing the adapter

Advertising
background image

20-COMM-E EtherNet/IP Adapter User Manual

Publication 20COMM-UM010G-EN-P

Chapter

2

Installing the Adapter

This chapter provides instructions for installing the adapter in a PowerFlex
7-Class drive. The 20-COMM-E Series B adapter, firmware revision 3.xxx
or later, can also be installed in a DPI External Comms Kit. In this case, see

Chapter 9

or the 20-XCOMM-DC-BASE Installation Instructions,

publication 20COMM-IN001, supplied with the kit.

Preparing for an Installation

Before installing the adapter, do the following:

• Make sure the Ethernet switch is the correct type. A ‘managed’ switch

that supports IGMP snooping is usually recommended. An ‘unmanaged’
switch can be used instead if RSLogix 5000 software, version 18.00 or
later, is used and all devices on the network are configured for ‘unicast’
I/O. For more details, see the following documents:

EtherNet/IP Media Planning and Installation Manual,

ODVA publication 148

EtherNet/IP Network Infrastructure Guidelines,

ODVA publication 35

Ethernet Design Considerations Reference Manual,

publication ENET-RM002

• Understand IGMP Snooping/Ethernet Switches

The 20-COMM-E adapter is a multicast device. In most situations, an
IGMP snooping (managed) switch is required. If more than one or two
20-COMM-E adapters are connected to the switch, a managed switch is
required—otherwise the drive may fault on a DPI Port x network loss.
The 20-COMM-E Series B adapter, firmware 4.001 or later, RSLogix
5000 software, version 18.00 or later, and a ControlLogix or
CompactLogix controller will support unicast. Unicast setup is required
when adding the drive to the I/O. When all adapters are set up as unicast
devices, then an IGMP snooping (managed) switch is not needed.

Topic

Page

Preparing for an Installation

2-1

Setting the Web Pages Switch (only Series B Adapter, Firmware 3.xxx or Later)

2-2

Connecting the Adapter to the Drive

2-3

Connecting the Adapter to the Network

2-6

Applying Power

2-6

Commissioning the Adapter

2-8

Advertising