Rockwell Automation 20-COMM-E PowerFlex EtherNet/IP Adapter - Manual (Page 233)

Adapter Parameters B-7
20-COMM-E EtherNet/IP Adapter User Manual
Publication 20COMM-UM010G-EN-P
48 [Peer Inp Status]
Displays the status of the consumed peer I/O input
connection.
Values: 0 = Off
1 = Waiting
2 = Running
3 = Faulted
Type: Read Only
49
50
[Peer A Output]
[Peer B Output]
Selects the source of the peer I/O output data. The
adapter transmits this data to the network.
Important: Changes to these parameters are
ignored when Parameter 51 - [Peer Out Enable]
is set to ‘1’ (On).
Default: 0 = Off
Default: 0 = Off
Values: 0 = Off
1 = Cmd/Ref
2 = Datalink A Input
3 = Datalink B Input
4 = Datalink C Input
5 = Datalink D Input
6 = Datalink A Output
7 = Datalink B Output
8 = Datalink C Output
9 = Datalink D Output
Type: Read/Write
Reset Required: No
51 [Peer Out Enable]
Determines if peer I/O output is on or off. Default: 0 = Off
Values: 0 = Off
1 = On
Type: Read/Write
Reset Required: No
52 [Peer Out Time]
Sets the minimum time that an adapter will wait
when transmitting data to a peer.
Important: Changes to these parameters are
ignored when Parameter 51 - [Peer Out Enable]
is set to ‘1’ (On).
Default: 10.00 Seconds
Minimum: 0.01 Seconds
Maximum: 10.00 Seconds
Type: Read/Write
Reset Required: No
53 [Peer Out Skip]
Sets the maximum time that an adapter will wait
when transmitting data to a peer. The value of
Parameter 52 - [Peer Out Time] is multiplied by
the value of this parameter to set the time.
Important: Changes to these parameters are
ignored when Parameter 51 - [Peer Out Enable]
is set to ‘1’ (On).
Default: 1
Minimum: 1
Maximum: 16
Type: Read/Write
Reset Required: No
54 [Access Control]
This parameter is only available for Series A
adapters, firmware revision 2.003 or earlier.
Sets the access to the Web interface and Web
configurable email notification feature.
Default: xxxx xx01
Bit Values: 0 = Disabled
1 = Enabled
Type: Read/Write
Reset Required: No
55 [Web Enable]
This parameter is only available for Series B
adapters, firmware revision 3.xxx or later.
Displays the setting of the adapter Web Pages
Switch (SW2) when the adapter was last reset.
Values: 0 = Disabled
1 = Enabled
Type: Read Only
Parameter
No. Name and Description
Details
Bit
Definition
No
t U
se
d
No
t U
se
d
No
t U
se
d
No
t U
se
d
No
t U
se
d
No
t U
se
d
No
t U
se
d
No
t U
se
d
No
t U
se
d
No
t U
se
d
E-m
ail
Confi
g
W
eb
Ena
ble
Default x x x x … x x x x x x 0 1
Bit 31 30 29 28 … 7 6 5 4 3 2 1 0