Rockwell Automation 20G PowerFlex 755 Drive Embedded EtherNet/IP Adapter User Manual
Page 14
14
Rockwell Automation Publication 750COM-UM001E-EN-P - October 2013
Chapter 1
Getting Started
❑ Drive and embedded adapter configuration tool, such as the following:
– PowerFlex 20-HIM-A6 or 20-HIM-C6S HIM
– Connected Components Workbench software, version 1.02 or later
Connected Components Workbench is the recommended stand-alone
software tool for use with PowerFlex drives. You can obtain a free copy
by:
•
Internet download a
•
Requesting a DVD at
Your local distributor may also have copies of the DVD available.
Connected Components Workbench software cannot be used to
configure SCANport-based drives or Bulletin 160 drives.
– DriveExplorer software, version 6.01 or later
This software tool has been discontinued and is now available as
freeware
at
. There are no plans to provide future updates to this tool
and the download is being provided ‘as-is’ for users that lost their
DriveExplorer CD, or need to configure legacy products not supported
by Connected Components Workbench software.
– DriveExecutive software, version 5.01 or later
A Lite version of DriveExecutive software ships with RSLogix 5000,
RSNetWorx MD, FactoryTalk AssetCentre, and ItelliCENTER
software. All other versions are purchasable items:
•
9303-4DTE01ENE Drive Executive software
•
9303-4DTS01ENE DriveTools SP Suite (includes
DriveExecutive and DriveObserver software)
•
9303-4DTE2S01ENE DriveExecutive software upgrade to
DriveTools SP Suite (adds DriveObserver software)
DriveExecutive software updates (patches, and so forth) can be obtained
at
. It
is highly recommended that you periodically check for and install the
latest update.
– BOOTP, version 2.1 or later, for network setup only
❑ Controller configuration software, such as RSLogix 5000 software, version
20.00 and earlier, or Studio 5000™ Logix Designer application, version
21.00 and later
❑ A computer connection to the EtherNet/IP network