Rockwell Automation 20G PowerFlex 755 Drive Embedded EtherNet/IP Adapter - Manual (Page 25)

Rockwell Automation Publication 750COM-UM001E-EN-P - October 2013 25
Chapter
3
Configuring the Adapter
This chapter provides instructions and information for setting the parameters to
configure the embedded EtherNet/IP adapter.
For a list of parameters, see Appendix B , Adapter Parameters. For definitions of
terms in this chapter, see the Glossary .
Configuration Tools The embedded EtherNet/IP adapter stores parameters and other information in
its own nonvolatile storage (NVS) memory. You must, therefore, access the
adapter to view and edit its parameters. The following tools can be used to access
the adapter parameters.
Topic Page
Configuration Tools 25
Using the PowerFlex 20-HIM-A6 or 20-HIM-C6S HIM to Access Parameters 26
Setting the Adapter IP Address 26
Setting the Data Rate 31
Selecting Master-Slave or Peer-to-Peer Hierarchy 32
Setting a Fault Action 38
Setting Web Access Control 40
Resetting the Adapter 41
Restoring Adapter Parameters to Factory Defaults 41
Viewing the Adapter Status Using Parameters 42
Updating the Adapter Firmware 43
Tool See
PowerFlex 20-HIM-A6 or 20-HIM-C6S HIM page 26
BOOTP server page 26
Connected Components Workbench software,
version 1.02 or later http://www.ab.com/support/abdrives/webupdate/
software.html
, or online help (installed with the software)
DriveExplorer software,
version 6.01 or later http://www.ab.com/drives/driveexplorer , or online help
(installed with the software)
DriveExecutive software,
version 5.01 or later http://www.ab.com/drives/drivetools , or online help
(installed with the software)