Rockwell Automation 20G PowerFlex 755 Drive Embedded EtherNet/IP Adapter - Manual (Page 176)

176 Rockwell Automation Publication 750COM-UM001E-EN-P - October 2013
Appendix E History of Changes
750COM-UM001C-EN-P,
November 2011
750COM-UM001B-EN-P,
October 2011
750COM-UM001A-EN-P,
January 2009
Change
In the Using Automatic Device Configuration (ADC) with RSLogix 5000 version 20 (or later) section of the manual:
• Revised the first statement in the Important table to read ‘ADC is enabled by default and will be triggered…’
• In the table below Figure 46:
– Changed the description for the ‘Enable Automatic Device Configuration’ row.
– Added the following statement at the end of the description for the ‘Fail Drive Connection on Peripheral Error’
row: Note that when a failure occurs, RSLogix will show both a configuration on Port 0 (drive) and Port ‘xx’
(peripheral) error.
• In step 5, added an Attention table.
• In step 7, added an Important table.
• In the ‘Special Considerations When Using a 20-750-S1 Safe Speed Monitor Module’ subsection, revised the last
statement in the Important table to read ‘These two parameters need to be changed manually after performing an
upload or after the ADC download’.
Change
Added references to ODVA publications for EtherNet/IP information.
In the Features section, added Automatic Device Configuration (ADC).
In the ‘Configuring/Verifying Key Drive Parameters’ subsection, revised steps for establishing the drive speed reference
from the network.
In the Setting a Master-Slave Hierarchy subsection ‘Enabling Datalinks To Write Data’, revised step 3 for better clarity.
In the Using RSLogix 5000 Drive Add-On Profiles (version 16 or later) subsection ‘Adding the Drive/Adapter to the I/O
Configuration’, added a TIP at the end of step 1.
Added the new section ‘Using Automatic Device Configuration (ADC) with RSLogix 5000 version 20 (or later)’.
In the Using RSLogix 5000 Generic Profile subsection ‘Adding the Drive/Adapter to the I/O Configuration’, corrected
Input Size and Output Size information in step 4.
In the ‘Using Reference/Feedback’ section, re-organized and added new information.
In Chapter 6 Explicit Messaging, added Table 8 and footnotes to message configuration screens throughout the chapter
about limitations when using DPI Parameter Object Class code 0x93 or Host DPI Parameter Object Class code 0x9F.
In the ‘Viewing and Clearing Events’ section, added more information.
In the Communications specifications subsection ‘Connection Limits’, added more information.
Added new Appendix E ‘History of Changes’.
Change
This was the first release of this manual.