Rockwell Automation 20G PowerFlex 755 Drive Embedded EtherNet/IP Adapter - Manual (Page 24)

24 Rockwell Automation Publication 750COM-UM001E-EN-P - October 2013
Chapter 2 Installing the Adapter
Commissioning the Adapter To commission the embedded EtherNet/IP adapter, you must set a unique IP
address. See the
Glossary for details about IP addresses. When using the adapter
switches, see Setting the IP Address on page 18 for details. When not using these
switches, a BOOTP server or adapter parameters can be used to set the IP address
after connecting the adapter to the network and applying power to the drive.
By default, the adapter is configured so that you must set the IP address using a
BOOTP server. For details, see
Using a BOOTP Server on page 26 . To set the IP
address using adapter parameters, see Using Adapter Parameters on page 30 .
IMPORTANT New settings for some adapter parameters (for example, Parameters 38 - [IP
Addr Cfg 1] through 41 - [IP Addr Cfg 4]) are recognized only when power is
applied to the adapter or it is reset. After you change parameter settings, cycle
power or reset the adapter.