Summary of changes, New and updated information – Rockwell Automation 20G PowerFlex 755 Drive Embedded EtherNet/IP Adapter User Manual
Page 3
Rockwell Automation Publication 750COM-UM001E-EN-P - October 2013
3
Summary of Changes
This manual contains new and updated information.
New and Updated
Information
This table contains the changes made to this revision.
Topic
Page
Added information about the Connected Components Workbench software tool.
Throughout
manual
Removed information for PLC-5, SLC 500, and MicroLogix 1100/1400 controllers. This information is now
provided in a separate document titled ‘Controller Examples for EtherNet/IP Network Communications
with PowerFlex 750-Series Drives’, publication 750COM-AT001.
In Chapter 1 in the subsection ‘User-Supplied Equipment’ under configuration tool, added Connected
Components Workbench software, a free configuration tool.
In Chapter 4 in the ‘Using Automatic Device Configuration (ADC) with RSLogix 5000 Software, Version
20.00 or Later” subsection, added new information to the introduction, along with a new Important
statement and a new Tip.