Rockwell Automation 20G PowerFlex 755 Drive Embedded EtherNet/IP Adapter - Manual (Page 42)

42 Rockwell Automation Publication 750COM-UM001E-EN-P - October 2013
Chapter 3 Configuring the Adapter
7. Press the (Enter) key again to display the warning pop-up box to
reset parameters to their factory default values.
8. Press the MOST
soft key to restore MOST parameters to factory defaults,
or press the ALL
soft key to restore ALL parameters. Or press the ESC soft
key to cancel.
9. Reset the adapter by cycling power to the drive or by using the HIM’s
Reset Device function located in the drive’s DIAGNOSTIC folder.
Viewing the Adapter Status
Using Parameters The following parameters provide information about the status of the adapter.
You can view these parameters at any time.
IMPORTANT When performing a Set Defaults, the drive may detect a conflict and
then not allow this function to occur. If this happens, first resolve the
conflict and then repeat this Set Defaults procedure. Common reasons
for a conflict include the drive running or a controller in Run mode.
Adapter Parameter Description
34 - [DLs From Net Act] The number of controller-to-drive Datalinks that are included in the network I/O
connection (controller outputs).
35 - [DLs To Net Act] The number of drive-to-controller Datalinks that are included in the network I/O
connection (controller inputs).
37 - [Net Addr Src] Displays the source from which the adapter IP address is taken. The source is determined
by the IP address switch settings shown in
Figure 1 , and whether Parameter 36 -
[BOOTP] is enabled or disabled. The source can be one of the following:
• ‘0’ (Switches)
• ‘1’ (Parameters)—uses the address from Parameters 38…41 [IP Addr Cfg x]
• ‘2’ (BOOTP)—the default
50 - [Net Rate Act] The data rate used by the adapter.
86 - [Fr Peer Status] The status of the consumed peer I/O input connection, which can be one of the following
values:
0 = Off
1 = Waiting
2 = Running
3 = Faulted
77 - [DLs Fr Peer Act] The number of peer-to-drive Datalinks that the drive is expecting.
88 - [DLs To Peer Act] The number of drive-to-peer Datalinks that the drive is expecting.