Rockwell Automation 20G PowerFlex 755 Drive Embedded EtherNet/IP Adapter - Manual (Page 64)

64 Rockwell Automation Publication 750COM-UM001E-EN-P - October 2013
Chapter 4 Configuring the I/O
6. Click the Port Properties icon to open the Properties dialog box.
There are two checkboxes related to ADC.
7. When finished, click OK.
8. Perform all previous steps for each peripheral in the treeview on the Drive tab.
a. Select the peripheral in the treeview.
b. Click the Port Properties icon to open the Properties dialog box.
9. When finished configuring the drive and peripherals, click OK to close the
Module Properties dialog box for the drive.
10. Click the Drive tab.
Checkbox Selection Description
Enable Automatic
Device Configuration See the Important note on page 60 and, depending on the Drive AOP version
being used, Version 4.01 Drive Add-on Profiles (AOPs) on page 60 or Version 4.02
(or later) Drive Add-on Profiles (AOPs) on page 61 for additional information about
ADC use and Logix behavior. ADC is disabled when unchecked, or enabled when
checked.
Fail Drive Connection
on Peripheral Error This selection is only available for peripherals. If you want to ensure that the
correct peripheral is present with the correct configuration before the controller
connects to the drive, check this box. If the peripheral is not essential to your use of
the drive (for example, a HIM that may or may not be present all the time),
uncheck this box. Note that when a failure occurs, RSLogix software will show
both a configuration on Port 0 (drive) and Port ‘xx’ (peripheral) error.
TIP When using version 4.01 Drive AOPs, skip to step 13.