Dell PowerVault ML6000 - Manual (Page 151)

Chapter 8 Library Managed Encryption
Configuring the Dell Encryption Key Manager (EKM) on the Library
Dell PowerVault ML6000 User’s Guide 151
7 If you are using a secondary key server for failover purposes, enter
the IP address or host name of the secondary key server into the
Secondary Key Server IP Address or Host
text box.
8 If you configured a secondary key server (previous step), enter the
port number for the secondary key server into the
Secondary Key
Server Port Number
text box. The default port number is 3801 unless
SSL is enabled. If SSL is enabled, the default port number is 443.
9 Click
Apply
.
10
Ensure all ports corresponding to the EKM servers are open on your
firewall to allow the library to connect to the servers.
Note: If you do not plan to use a secondary key server, you may
type a zero IP address, 0.0.0.0, in the
Secondary Key Server
IP Address or Host
text box, or you may leave the text box
blank.
Note: If you are using a secondary key server, then the port
numbers for both the primary and secondary key servers
must be set to the same value. If they are not,
synchronization and failover will not occur.
Note:
You cannot edit the encryption system configuration
settings when any partition is enabled for library
managed encryption. If this happens, go to Setup >
Encryption > Partition Configuration, change all Dell
EKM partition settings from Library Managed to
Application Managed. Then make your changes to the
system configuration settings. Finally, go back and
change all the Dell LME partition settings to Library
Managed.