Dell PowerVault ML6000 - Manual (Page 394)

Chapter 13 Troubleshooting
Resetting FC I/O Blade Ports
Dell PowerVault ML6000 User’s Guide 394
The paths to open the appropriate screens are as follows:
• From the Web client, select
Setup > FC I/O Blades > FC I/O Blade
Control
.
• From the operator panel, select
Setup > FC I/O Blades > FC I/O Blade
Control > Remove Blade
.
Resetting FC I/O Blade Ports
Administrators can reset individual ports on FC I/O blades. Resetting
these ports can help troubleshoot FC I/O blade issues. The
Setup - Blade
Control
screen allows you to perform the Reset Port operation on a
selected FC I/O blade port.
Resetting an FC I/O blade port will cause a temporary loss of
communication with connected hosts. The screen will display a warning
message about the communication loss and ask you to confirm that you
want to proceed.
Note:
Before permanently removing the FC I/O blade, verify the
location of the FC I/O blade. See Identifying FC I/O Blades on
page 393.
Note: This operation should not be performed concurrently by
multiple administrators logged in from different locations.
You can access the appropriate screens, but you cannot apply
changes while another administrator is performing the same
operation.
Note:
This operation should not be performed concurrently by
multiple administrators logged in from different locations.
You can access the appropriate screens, but you cannot apply
changes while another administrator is performing the same
operation.