Dell PowerVault ML6000 User Manual
Page 290
Chapter 12 Installing, Removing, and Replacing
Permanently Removing 9U Library Expansion Modules From an Existing Library
Dell PowerVault ML6000 User’s Guide
290
7
Open the module’s access door and raise the guide pin by pulling it
up and turning it slightly as if it were a screw. Otherwise, the guide
pin may scratch the front doors of the module beneath it.
8
From the front of the library, slide the entire module toward you and
lift it off of the module below it.
9
Repeat these procedures for each module that you intend to remove.
10
Remove and replace the cover plates, if appropriate (see
).
a
If you plan to stack the 5U Library Control Module at the top of
the library, and if a 9U Library Expansion Module will be located
below it, remove the 5U Library Control Module’s bottom cover
plate and the 9U Library Expansion Module‘s top plate.
b
If you plan to stack the 5U Library Control Module between 9U
Library Expansion Modules, remove both the top and bottom
plates of the 5U Library Control Module. Also remove the top
plate of the 9U Library Expansion Module located below the 5U
Library Control Module and the bottom plate of the 9U Library
Expansion Module located above the 5U Library Control
Module.
c
If you plan to stack the 5U Library Control Module at the bottom
of the library, and if a 9U Library Expansion Module will be
located above it, remove the 5U Library Control Module’s top
plate and the 9U Library Expansion Module’s bottom plate.
Caution:
Before removing the 5U Library Control Module’s
bottom cover plate, the robot assembly must be