Default configuration settings, Setup wizard tasks, Work through all of the screens as prompted (see – Dell PowerVault ML6000 User Manual
Page 60: Default, Configuration settings
Chapter 5 Configuring Your Library
Using the Setup Wizard
Dell PowerVault ML6000 User’s Guide
60
• You cannot log in to the library from the Web client until you have
configured network settings on the operator panel. To change IPv4
settings and configure IPv6 settings, go to
Setup > Network Mgmt
.
• You can return to the
Setup Wizard
from the Web client.
• Any administrators you create will also be able to use the Setup
Wizard from the Web client as well as
Setup
and
Operations
menu
commands to reconfigure the library.
• If necessary, you can cancel out of the
Setup Wizard
on the operator
panel and begin using the library locally with the default settings in
place. If you accept the default network configuration settings, you
will not be able to access the library remotely from the Web client.
You can, however, use
Setup > Network Mgmt
on the operator panel at
any time to modify network settings. See
on page 60 for more information.
Default Configuration
Settings
5
The default configuration settings are as follows:
•
License keys:
COD, 41 slots minimum. The total number depends
on number of pre-activated slots purchased.
•
Network settings:
DHCP enabled, IPv6 disabled
•
Import/export (I/E) station slots:
6
•
Cleaning cartridge slots:
0
•
Partitions:
By default, the library creates partitions and assigns
available library resources proportionately among the partitions,
grouping tape drives according to distinct combinations of tape
drive interface type (SCSI, FC, or SAS) and tape drive media
type. To mix tape drive types/media types within a partition,
create partitions manually. See
Setup Wizard Tasks
5
As you work through the
Setup Wizard
screens, follow the on-screen
instructions.
The
Setup Wizard
screens contains only a subset of all configuration
options. The
Setup
and
Operations
menus contain most configuration
options, including those in the
Setup Wizard
. This section includes