Dell PowerVault ML6000 - Manual (Page 246)

Chapter 12 Installing, Removing, and Replacing
Installing a New Multi-Module Library Configuration
Dell PowerVault ML6000 User’s Guide 246
13 Configure the library using the operator panel Setup Wizard.
14
Add the tape cartridges to the library using the I/E station.
15
If your host application inventories the location of each tape cartridge
in the library, open the host application and re-inventory to sync the
logical inventory with the physical inventory of the library.
Installing a New Multi-Module Library Configuration
Use this procedure for installing a new multi-module library. A multi-
module library contains a 5U Library Control Module and one or two 9U
Library Expansion Modules.
There are no restrictions on where the 5U Library Control Module can be
installed in the library configuration. However, the recommended
placement of the control module for library configurations up to 32U is
on top of all installed 9U expansion modules. The recommended
placement of the control module for 41U library configurations is on top
of three 9U expansion modules and below the top expansion module.
9U Library
Expansion Module
5U Library Control
Module
9U Library
Expansion Module
9U Library
Expansion Module
9U Library
Expansion Module