Dell PowerVault ML6000 - Manual (Page 399)

Chapter 13 Troubleshooting
Interpreting LEDs
Dell PowerVault ML6000 User’s Guide 399
Blade Port LEDs 13
This section describes blade port LEDs.
LCB Ethernet Hub Port LED 13
The LED for an Ethernet hub port is located above the port. Use Table 11
to interpret Ethernet hub link activity on an LCB.
Table 11 LCB Ethernet Hub
Link Activity
Fibre Port Link LED on FC I/O Blades 13
A fibre port link LED on a FC I/O blade shows the current state of an FC
link and indicates whether or not the link is ready to transmit commands.
The link LED for an FC I/O blade fibre port is located either below or
above the port. For each link LED pair on the FC I/O blade, the LED on
the left belongs to the fibre port below. The LED on the right belongs to
Blue Power
Control
status
• Blinks once every 10 seconds — Normal. Blade is powered on.
• Solid ON —
• LCB — Error condition. Power off library before removing or
replacing the LCB.
• FC I/O blade — Swap mode: Blade is ready to be removed or
replaced.
• Solid OFF — Blade is not receiving power.
LED Color Represents Fibre Port Link Status
Amber Link and activity • Solid ON — The link is up.
• Blinks — The link is up and currently transmitting
commands.
LED Color Represents Blade Status