Dell PowerVault ML6000 User Manual
Page 323
Chapter 12 Installing, Removing, and Replacing
Removing and Replacing the Library Control Blade and LCB Compact Flash Card
Dell PowerVault ML6000 User’s Guide
323
7
After inserting the new LCB, secure it by depressing both of the LCB
latch hooks into the blade. The LCB will fit snugly into its slot.
8
Reconnect all cables to the new LCB.
9
Power on the library.
The green power light on the front panel turns on. The screen may
remain dark for up to 5 minutes. Then an “Initialization In Progress”
screen displays. The initialization process can take up to 30 minutes
depending on library configuration.
When initialization is complete, the screen will display “Upgrade
Notification: Compact Flash Replacement” screen shown below.
Caution:
From this point forward until the process is complete,
do NOT remove power from the library! Doing so
may cause failure and cause LCB to become unusable.