Dell PowerVault ML6000 - Manual (Page 333)

Chapter 12 Installing, Removing, and Replacing
Installing the Library in a Rack
Dell PowerVault ML6000 User’s Guide 333
8 Insert the new power supply into the vacant power supply slot.
When inserting the power supply, make sure that you insert it
correctly with its on/off switch located at the bottom of the supply,
below the handle. The power supply must be level to slide in
smoothly.
9
Tighten the power supply’s thumbscrews to secure the power supply
to the library module.
10
Reconnect the power supply’s power cord.
11 Turn on the power supply’s power.
12
Check the status of the power supply’s LEDs. The top green LED and
the blue LED should be solidly lit.
13
Power on the library.
14
Check the status of the power supply’s LEDs. The two green LEDs
should be solidly lit, and the blue LED should be off.
Installing the Library in a Rack
All PowerVault ML6000 libraries taller than 14U must be installed in a
rack. The rack secures the bottom module, and all other modules are then
secured to the bottom module.
The rack-mount kit secures your library within a rack. These instructions
explain how to install your stand-alone library into a rack and how to
install additional modules into an existing rack.
Installing the modules into the rack requires at least two people.