Dell PowerVault ML6000 - Manual (Page 301)

Chapter 12 Installing, Removing, and Replacing
Replacing the 5U Library Control Module
Dell PowerVault ML6000 User’s Guide 301
6 Open the module’s access door and raise the guide pin by pulling it
up and turning it slightly as if it were a screw. Otherwise, the guide
pin may scratch the front doors of the module beneath it.
7 Slide the entire module toward you and lift it off of the module below
it.
Replacing the 5U Library
Control Module
12
1
If not already removed, remove the tape drives and power supplies
from the 5U Library Control Module you are replacing.
2
Using the Phillips #2 screwdriver (for the top cover plate) and the
T10 TORX screwdriver (for the bottom cover plate), remove the new
5U Library Control Module plates from the top and bottom of the
module, as necessary.
1 Guide pin
2 Thumbscrew