Metalfab SEW Eurodrive MOVIMOT MM..C - Manual (Page 136)

136
Operating Instructions – MOVIMOT® MM03C - MM3XC
10
Diagnostics of MOVIMOT® with integrated AS-Interface
Diagnostics
Starting the diag-
nostic monitor 1. Isolate MOVIMOT
®
drive from the supply, safeguarding it against unintentional
power-up! Dangerous voltages may still be present for up to 1 minute after
shutdown!
2. Remove screws at MOVIMOT
®
inverter and detach MOVIMOT
®
inverter.
3. Remove a closing plug from the MOVIMOT
®
terminal box.
4. Attach the modular jack plug connector 4/4 (RJ11) to the socket X50. Feed the cable
through the open cable entry.
5. Place the MOVIMOT
®
inverter on the terminal box and secure it.
6. Switch in the electronics supply voltage.
7. Start the MOVITOOLS manager on the PC. The following window displays:
8. In the "PC-COM" selection menu, select the serial interface used in your PC.
9. Activate the button "Single Inverter (Peer-to-Peer)" in the window area "Connect to."
06458AEN