Metalfab SEW Eurodrive MOVIMOT MM..C - Manual (Page 17)

Operating Instructions – MOVIMOT® MM03C - MM3XC
17
4
Modular terminal box
Mechanical Installation
4.2 Modular terminal box
Turning the termi-
nal box In principle it is recommended to purchase factory pre-fabricated MOVIMOT
®
systems
with the correct position of cable entries. In exceptional cases, the position of the cable
entries can be turned to the opposite side (only for designs with modular terminal box).
1. Isolate MOVIMOT
®
drive from the supply, safeguarding it against unintentional
restarting! Dangerous voltages may still be present for up to 1 minute after
shutdown!
2. Label the connections before disconnecting them for later reassembly.
3. Disconnect the supply system, control and sensor connections.
4. Remove screws [A] and detach MOVIMOT
®
inverter [B].
5. Loosen screws [C] and remove terminal box [D].
51819AXX
[D]
[B]
[C]
[A]