Metalfab SEW Eurodrive MOVIMOT MM..C - Manual (Page 55)

Operating Instructions – MOVIMOT® MM03C - MM3XC
55
7
Description of the DIP switches S2
Startup of Standard Design
7.4 Description of the DIP switches S2
DIP switches
S2/1 Motor type
• With IEC and NEMA motors, DIP switch S2/1 must always be set to OFF!
• With DZ motor with rated voltages of 220/380 V, 60 Hz (only available in Brazil), the
DIP switch must always be set to ON.
DIP switches
S2/2 Releasing the brake without enable
With activated switch S2/2 = "ON", the brake can also be released if no drive enable is
present.
Operation with
braking resistor The special function is not in effect if operated with braking resistor.
Function with ter-
minal control
(address = 0) With terminal control, the brake can be released by setting terminal f1/f2 if the following
requirements exist:
Functions in bus
operation In bus operation, the brake is released through control in the control word.
Terminal condi-
tion Enable condition Fault condi-
tion Brake function
R L f1/f2
"1"
"0" "0"
"1" "0" Unit enabled No
Unit fault Brake is controlled by MOVIMOT ® ,
setpoint f1
"1"
"0" "0"
"1" "1" Unit enabled No
Unit fault Brake is controlled by MOVIMOT ® ,
setpoint f2
"1"
"0" "1"
"0" "0" Unit not
enabled No
Unit fault Brake closed
"1" "1" "1" Unit not
enabled No
Unit fault Brake closed
"0" "0" "1" Unit not
enabled No
Unit fault Brake released for manual procedure
All conditions pos-
sible Unit not
enabled Unit fault Brake closed
52117AXX
PO = Process output data PI = Process input data
PO1 = Control word PI1 = Status word 1
PO2 = Speed (%) PI2 = Output current
PO3 = Ramp PI3 = Status word 2
DO = Digital outputs DI = Digital inputs
MOVIMOT
®
PO1 PO2 PO3 DO
Master
-+
PI1 PI2 PI3 DI
PO
PI
0 0
I