Cub Cadet 7000 Series - Manual (Page 37)

6 - 43
7264 Compact Tractor
2. TRANSMISSION HOUSING COVER:
2.1. Remove all four hex cap screws securing the
rear portion of the transmission housing cover to
the transmission housing using a 9/16” socket
and wrench. See Figure 2.1.
NOTE: All four rear hex cap screws are shorter
than the remain hex cap screws securing the
transmission housing cover to the transmission
housing. Loctite™ the threads and torque them
between 220 and 280 In. Lbs. during assembly.
Figure 2.1
Hex Screws
Transmission Cover
2.2. Remove the remaining hex cap screws securing
the transmission housing cover to the transmis-
sion housing using a 9/16” socket. See Figure
2.2.
NOTE: The hex cap screw that is front and cen-
ter is longer than the rest. Loctite™ the threads
and torque them between 220 and 280 In. Lbs.
during assembly.
2.3. Thread one long hex cap screw back into the
transmission housing until the head is 1/4” away
from the transmission housing cover, just in front
of the rock shaft assembly. See Figure 2.3.
2.4. Protect the right bottom side of the rock shaft.
2.5. Position a pry bar under the material protecting
the rock shaft, and across the top of the long
screw.
Figure 2.2
Hex Screws
Transmission Cover
Hex Screws
Figure 2.3
Long Screw
Rock Shaft
Protective Material
Transmission
Cover
Pry Bar
6