Changing a snap-on presser foot – SINGER 5160 User Manual

Page 24

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

S I N G E R

Changing a

snap-on presser

foot

TURN OFF THE MACHINE BEFORE CHANGING A

PRESSER FOOT.

Your machine is assembled with a general purpose

presser foot. You may easily replace it with other

presser feet, which are attached to the same shank by

following the instructions;

1. Turn hand wheel toward you until the needle is in its

highest position and lift presser foot.

2. Lift lever "A" slightly up. The presser foot will snap off

the shank (illustration 1).

3. Place the new presser foot with its pin under the

center of shank fitting. Lower presser foot and it will
be firmly connected (illustration 2).

22

Advertising